Installation

Brackets should be placed at the width of blind’s head rail 6mm past each end. The bracket doesn’t necessarily need to touch the inside face of the window frame.
Align the top of the centre support bracket with the top mounting bracket before installation. Install with bigger flap of the centre support bracket in the top side and clear of the slat ladder positions Push rail into brackets. Then press gate to close brackets

To install the facia onto the head rail use one of the following methods as supplied with your blind.

Metal Bracket	Plastic Clip	Velcro Pad

Operating your blind

To lower the blind pull the cord (with acorn on) towards the centre of the blind to release the locking mechanism and allow the blind to lower. (Only raise / lower the blind when the slats are in the open position.)
To lock the blind pull the cord (with acorn on) towards the edge of the blind and slightly release allowing locking mechanism to locate. (Only raise / lower the blind when the slats are in the open position.)
To tilt the blind (cord operation) pull one cord or one side of the endless cord loop, or (wand operation) twist the wand
either one way or the other.

Caring for you blind
Do not allow moisture to settle on the blinds. - Wipe with a clean damp cloth.
Do not use any type of detergent to clean your blind. - Clean damp cloth only.
Do not oil or lubricate any part of the blind.
Wood Slat blinds must only be cleaned using a dry soft cloth.